![]() Strip 1/2” (13 mm) of plastic insulation off the end of each wire for both the valve and sprinkler timer wires.Level the timer and install the second screw in one of the pre-formed mounting holes located on lower back cabinet to secure the timer.Hang the timer on the installed screw using the keyhole slot located in upper back cabinet.8 screw (included) into the wall, leaving the screw head protruding 1/8” (3 mm) from the wall. Tip: Use the expanding anchors (included) for plaster, masonry or drywall installations. Small Flathead Screwdriver (included in hardware package).Tip: If replacing a timer, it is helpful to take a photo of the wires before you remove them from the old timer. ![]() Important: Timer is weather-resistant to UL-50 and ETL®Listings, but should not be placed in areas where continuous water could cause damage.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |